Sometimes you want to save water and a faucet aerator won't work - either because it won't fit properly or simply because someone keeps removing it.
This sink flow controller is the solution to the problem. Located under the sink, flow controllers go undetected by the faucet user.
Easy to install. Install the flow controllers directly under the counter between the faucet and supply line. Never have to worry about the flow rate if the faucet aerator is removed! Important note: If you have two inlet connections (one hot and one cold), the maximum output of the faucet is the sum of the hot and cold water flow rates combined. Choosing 2 - . 5 gpm flow controllers produces a flow rate of 1 gpm.
You choose your flow rate. The sink flow controller is pressure compensating so it works well if you have low or varying water pressure.
- Chrome Plated Solid Brass
- Pressure Compensating – holds flow rate steady 20psi to 80psi
- Male 1/2" to Female 1/2"
- Choose from:
1 = 0.25 gpm, 2 = 0.5 gpm combined hot and cold
1 = 0.5 gpm, 2 = 1.0 gpm combined hot and cold
1 = 0.6 gpm, 2 = 1.2 gpm combined hot and cold
1 = 0.75 gpm, 2 = 1 .5 gpm combined hot and cold
1 = 0.9 gpm, 2 = 1.8 gpm combined hot and cold
1 = 1.0 gpm, 2 = 2.0 gpm combined hot and cold
1 = 1.5 gpm, 2 = 3.0 combined hot and cold
1 = 1.8 gpm, 2 = 3.6 gpm combined hot and cold
- Made in the USA
- IMPORTANT: Over tightening may cause the washers to compress excessively and leak. When installing, HAND TIGHTEN then 1/4 turn with wrench.
wmcfcv